|
Navigation: Home -> Find Diagnostic Connector |
Subaru Automatic Transmission Diagnostic Connectors |
Subaru Automatic Transmission - Please select the connector for your vehicle from the options below.
|
| |
|
|
|
This is an OBD2 / EOBD standard 16 pin data link connector
To get a list of codes that relate to this system click here
This connector is usually located under the driver side dash panel.
|
|
|
|
|
|
|
Diagnostic Link Connector No. 90
Year range: 1984 to 2006
Locations: N/A
|
|
| | | For Subaru or Legacy, there are three options below. | Subaru or Legacy |
| Some vehicles have the ability to read two types of codes. MEMORY codes are those that were detected previously and stored. PRESENT codes are those that are existing at the present time. Present codes can be read if the CEL/SRS/Power light is flashing. Memory codes can be initiated by linking the correct pins of the diagnostic connector. | Memory > | | | Present > | | Unlike other makes, Subaru uses a series of actions to trigger the diagnostic code reading state rather than a connector | Justy > | | | | For L-Series or Leone, there are two options below. | L-Series or Leone |
| | Memory > | | | Present > |
|
|
|
|
| < Back |
|
All content copyright Rennacs Limited, 2008.
All products names mentioned herein should be considered registered trademarks
of their respective owners.
For comments and feedback please email comments@rennacs.com
Disclaimer
|
