1 Warm the engine to operating temperature.

2 Turn the ignition on.

3 Connect the terminals 1 and 8 with your own jumper wire,(Click here for details), for 2 seconds . Note: Only do this once with the ignition ON (twice will erase all codes).

4 Read codes as described in the Code Format Description below.

5 Press the continue button to enter the code numbers and get the code description.

• The code is made up of four groups of flashes each representing a digit.

• A long flash indicates the 'thousands' digit.

• 'Hundreds' 'Tens' and 'Ones' are groups of short flashes respectively.

• A long pause separates each trouble code.

• A shorter pause separates each group of flashes

• Upper Code Format Diagram A shows code No. 1132

• Please note: A '0' digit is indicated by 10 flashes with this system.

• Each code is made up of two series of flashes.

• The long flashes indicate the 'hundreds' digit, however can be a value up to 13 (eg 13 flashes = Thirteen Hundred).

• The short flashes indicate the 'ones' digit, however can a value up to 15.

• A long pause separates each code sequence.

• The top Code Format Diagram shows code No. 102.

• The bottom Code Format Diagram shows code No. 111.